Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Appliance description
6.
Appliance description
Standard delivery
WUT illustration
1 Swivelling spout with aerator and non-return valve to pre-
vent dripping
2 Tap body
3 Gasket
4 Spring sleeve
5 Mating fitting (spanner size 13)
6 WUT: Moulded plastic fitting for kitchen sink installation
7 Butterfly valve
8 Fitting G 3/8
7.
Installation
f Secure the tap with gasket, spring sleeve and mating fitting.
f
f WUT: Use the moulded plastic fitting to secure the tap in the
f
kitchen sink.
f Fasten the spout to the tap body.
f
10
| WST | WUT
7.1
Water connection
Material damage
!
With non-pressurised water heaters, observe the max-
imum permissible flow rate when the tap is fully open
(see chapter "Specification / Data table").
f If the flow rate is exceeded, install the supplied but-
f
terfly valve in the cold water line.
1
Material damage
!
The water heater can leak.
f Never subject the water heater to water pressure.
f
f Do not interchange the connection hoses.
f
2
Note
Ensure that the connection hoses are not kinked or under
tension during installation.
3
4
5
6
7
8
f Connect the short connection hose to the angle valve of the
f
cold water supply line.
f Connect the long connection hose marked blue to the "Cold
f
water inlet" connection on the water heater.
f Connect the long connection hose marked red to the "DHW
f
outlet" connection on the water heater.
8.
Commissioning
f Thoroughly flush the cold water supply line.
f
f Filling the water heater: Turn the temperature adjusting tap
f
head to max. temperature (fully anti-clockwise) and open the
draw-off valve.
f Wait until water flows from the outlet, then switch on the
f
water heater.
www.stiebel-eltron.com
Publicité
Chapitres
Table des Matières
