Additional Information - Sunbeam Hospitality 1640-099 Mode D'emploi

Table des Matières

Les langues disponibles

The Hair Dryer has three heat settings. To control the heat settings, toggle the switch to the desired temperature

for "LOW" heat

for "meDIUm" heat and

With the control setting switch in the "OFF" position, plug the Hair Dryer into a standard 125-volt AC outlet.

Select speed (airflow) and heat settings that are most appropriate to your needs and that will deliver the best results.

The control setting switch marked "OFF, "

Toggle the switch until it clicks into position for the desired speed.

When finished using the Hair Dryer, move the control switch to the "OFF" position and unplug the cord from

the outlet.

COOL SHOT BUTTON (Refer to Diagram)

To finish styling, use the

NIGHTLIGHT (HD3001 only)

Use the Dimmer Switch located on the lower portion of the wall mount to turn the nightlight on/off and to

adjust desired brightness.

DUAL WATTAGE SWITCH (HD3001 only)

This switch allows the Hair Dryer to change from 1875 watts to 1600 watts. The switch is located under the

hinged rear cover.

DISPOSABLE LINT FILTER (HD3001 only)

Disposable Lint Filter should be replaced every 6 months. Open hinged rear cover, remove and discard lint filter

and replace with new one.

Use your SUNbeAm® Hospitality Hair Dryer with care. Directing a high volume of heat continuously to one area can

overheat hair and scalp. When using a High heat setting, hold the blower opening a few inches away from the hair,

drying one section at a time. Work layers of hair in quick strokes. Keep the dryer in motion until drying and styling

are complete.

This dryer is equipped with an appliance leakage circuit interrupter (ALCI) for your safety. This device is designed

to make the appliance inoperable under some abnormal conditions (such as accidental immersion in water).

After the appliance is plugged in, you must check your protective device as follows:

1. Press the "Reset" button on the ALCI device.

2. Press the "Test" button. The "Reset" button will pop out. This verifies that the protective device is working

properly.

3. Press the "Reset" button once more to reactivate the safety device and use

your appliance.

REPEAT THE AbOvE PROCEdURE bEFORE EACH USE

TO CONFIRM THAT THE PROTECTIvE dEvICE IS OPERATINg.

To Use Your Hair dryer

for "HIGH" heat.

"LOW, "

"HIGH" controls the airflow speed of the Hair Dryer.