babymoov Babyphone Expert Care Notice D'utilisation page 9

2. Operation using the (AC adapter supplied)
The transmitter can be operated on AC mains using
the supplied 6V AC adapter. Connect the output
plug of adapter to DC jack (7) of the transmitter.
Connect the adapter to the mains. The power supply
from the battery will be cut off once the receiver is
mains-operating.
N.B. : The communication range is longest when the
transmitter is operated on AC mains.
B / Receiver
1. Operation from battery pack
The Li polymer battery pack is already installed in
the unit.
2. Recharging and operation on the base
Before using the receiver for the first time, make
sure it is turned off and recharge it on its base. The
charge indicator will show a red light. Once the
battery is fully charged (average time 3 hours) the
indicator will turn green. The receiver is then ready
to be turned on and used. If you decide to leave
the receiver on its base, when it detects that the
charge level is too low the base will automatically
start recharging the battery.
N.B.: TO ENSURE MAXIMUM LIFE FOR YOUR
BATTERY, WAIT UNTIL IT IS COMPLETELY
DISCHARGED BEFORE RECHARGING IT.
Your transmitter and receiver are already tuned to the same channel: you can use them immediately
without carrying out this step. If you notice any interference, follow the procedure for setting your transmitter
and receiver to another channel.
Transmitter
Press down the lock button and slide open the battery
cover. Remove the batteries.
• With help of a pointed object, select one of the two
settings of the channel selector (knob 1).
• Then select your digital code by choosing one of
the eight possible combination with the knobs 2, 3
and 4.
SETTING OF CHANNELS
BABY MONITOR EXPERT CARE • Instruction Manual
9