Care And Cleaning - Marvel ML15WSG0 Série Instructions D'installation, D'utilisation Et D'entretien

Front Grille
Be sure that nothing obstructs the required air flow open-
ings in front of the cabinet. At least once or twice a year,
brush or vacuum lint and dirt from the front grille area (see
page 4).
CAUTION
!
SHOCK HAZARD: Disconnect electrical power from the
appliance before cleaning with soap and water.
Cabinet
The painted cabinet can be washed with either a mild soap
and water and thoroughly rinsed with clear water. NEVER
use abrasive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Care of Appliance
1. Avoid leaning on the door, you may bend the door
hinges or tip the appliance.
2. Exercise caution when sweeping, vacuuming or mop-
ping near the front of the appliance. Damage to the
grille can occur.
3. Periodically clean the interior of the appliance as
needed.
4. Periodically check and/or clean the front grille as
needed.
In the Event of a Power Failure
If a power failure occurs, try to correct it as soon as pos-
sible. Minimize the number of door openings while the
power is off so as not to adversely affect the appliance's
temperature.

CARE AND CLEANING

Light bulb replacement
DISCONNECT THE POWER CORD BEFORE AT-
TEMPTING LIGHT BULB REPLACEMENT. Failure
to do so may result in an electrical shock that could
severely injure you.
The wine cellar uses one, 25 watt incandescent light bulb to
illuminate the interior of the wine cellar. The light bulb is a
very reliable electrical component, but should it not function
properly, please call the dealer where you purchased your
wine cellar from for a replacement light bulb. Use only an
original equipment light bulb from your dealer or Marvel.
Do NOT under any circumstance use a light bulb that
exceeds 25 watts!
To replace the light bulb, disconnect power to the unit. Un-
screw the old light bulb located behind the display housing
at the top of the unit. Set the old light bulb aside. Screw
the new light bulb into place. Reconnect power to the unit.
Check to see if the light bulb operates properly to complete
the installation.
The light bulb is not covered by your warranty. A replace-
ment bulb can be obtained from your dealer or from Marvel.
13
WARNING
!
WARNING
!