Philips 9000 Série Mode D'emploi page 23

3 Place the shaver in the holder (1), tilt the shaver backwards (2) and
press down the top cap to connect the shaver ('click') (3) (Fig. 17).
The battery symbol starts to flash, which indicates that the shaver
is charging.
4 Press the on/off button on the SmartClean system to start the
cleaning program (Fig. 48).
During the rinsing phase, the rinsing symbol flashes. When the
rinsing phase is done (after approx. 10 minutes), the rinsing symbol
lights up continuously.
SmartClean system Plus only:
phase starts automatically. During this phase, the drying symbol
flashes. When the drying phase is done (after approx. 4 hours), the
drying symbol lights up continuously (Fig. 49).
When the cleaning program is done, the ready symbol lights up
continuously (Fig. 50).
30 minutes after the cleaning program and charging have been
completed, the SmartClean system switches off automatically.
The battery symbol lights up continuously to indicate that the
shaver is fully charged (Fig. 50). Charging takes approx. 1 hour.
5 SmartClean system Basic only: To let the shaver dry, you can
leave it in the SmartClean system until your next shave. You can
also remove the shaver from the SmartClean system, shake off
excess water, open the shaving unit and let the shaver air dry.
Note: If you press the on/off button of the SmartClean system during
the cleaning program, the program aborts. In this case, the rinsing or
drying symbol goes out.
Note: If you remove the supply unit from the wall socket during the
cleaning program, the program aborts.
Replacing the cartridge of the SmartClean system
Replace the cleaning cartridge when the replacement symbol flashes
orange or when you are no longer satisfied with the cleaning result. If
you clean the shaver in the SmartClean system once a week, the
SmartClean cartridge lasts approximately three months.
After the rinsing phase, the drying
19
English