Publicité
DIAGNOSTICS
Led Display
1x Red, 1x Green, 1x Blue
Fast Purple Blink
Fast Amber Blink
1x Constant Amber Blink
2x Constant Amber Blink
7x Amber Blink
1x Green Blink
1x Amber Blink
État de la Del
1x Rouge, 1x Verte, 1x
Bleue
Clignotement Rapide
Mauve
Clignotement Rapide
Ambre
1x Clignotement Ambre
Constant
Page 15 / 17
Event
Boot Sequence
Installer Mode for Validation testing
Factory Reset
Unable to sync with Digital Remote
starter during EVO-START power-up
Validation pending
(make sure that the
EVO-START yellow (+) ignition wire is properly
connected to the vehicle's (+) ignition wire.)
Pit-Stop Mode Not Available
Command sent to Remote starter
succeeded
Command sent to Remote starter failed
Évenement
Séquence de démarrage
Mode installateur pour faire la
Validation
Réinitialisation d'origine
Incapable de syncroniser avec le
démarreur a distance digital durant
la mise sous tension du EVO-START.
DIAGNOSTIQUES
Action
N/A
Cycle ignition OFF to send an Unlock command
EVO-START2
Restart
Disconnect and Re-connect EVO-START main
harness. Verify Protocol selection.
Perform Validation Step:
a. Disconnect the
b. Cycle ignition to the ON position
c. Re-Connect the
Press the programming button)
d. The LED will blink Purple rapidly for 15 seconds
e. During this period, Cycle ignition to the OFF
position
f. If the vehicle door's unlocks, your programming is
successful.
Shutdown and Restart vehicle's engine and
retry Pit-stop mode and/or wrong DATA-LINK
communication port
Remote starter will execute the command sent from
ANT
EVO-START2
EVO-START2
Verify
wrong DATA-LINK communication port
Action
N/A
Mettre l'ignition a la position OFF pour envoyer
une commande de Déverrouillage
Refaire la programmation du module EVO-
ANT
START2
Débrancher et Re-brancher le harnais
principal du module EVO-START2
la sélection du protocol
EVO-START2
ANT
programming
ANT
EVO-START2
unit
EVO-START2
ANT
unit (DO NOT
unit
ANT
protocol selection and/or
ANT
. Véerifi er
ANT
Publicité
