Bimar PMS100 Mode D'emploi page 13

 To avoid all risk of electric shock, never immerse the
plug, the power cord or the appliance in water or any
other liquid.
 If the power cord is damaged, it must be replaced by
the manufacturer or its aftersales service, or by a
person with similar qualifications, to prevent all risks.
 This appliance is not intended for operation by means
of an external timer or with a separate remote control
system, to avoid the risk of fire if the appliance is
covered or not correctly positioned.
INSTALLATION
 After removing the packaging, check that the appliance is intact; if in doubt, do
not use it and call in qualified staff. Packaging components (plastic bags,
expanded polystyrene, nails, etc.) must not be left within reach of children since
they are potentially hazardous; dispose of them in accordance with the current
law.
 Before connecting the appliance, check that the voltage values marked on the
nameplate are the same as those of the electrical mains, and that the power
socket is properly earthed. If the appliance's plug is not compatible with the
socket, have the socket replaced with another of suitable type by qualified staff,
who must ensure that the socket's wire gauge is suitable for the appliance's
power draw. Check that there are no other appliances drawing large amounts of
power on the electrical line, to avoid overloads and fire risks. In general, the use
of adapters and/or extension leads is not recommended; if their use is
unavoidable, they must comply with current safety regulations and their current
rating (amps) must be no lower than the maximum current draw of the appliance.
 Before each use, check that the appliance is in good condition and ensure that
the power cord is not damaged and do not switch it on unless certain it is intact:
if in doubt, call in qualified staff.
 The power socket must be accessible so that the plug can be removed easily in
an emergency.
 The appliance must not be placed just below a power socket.
 Take care to keep the appliance well away from the edge of the worktop and out
of reach of children.
 Place the appliance:
- well away from other heat sources (e.g. ovens, hobs, etc.), flammable materials
(plastic bags, curtains, etc.), explosive materials (spray cans) and materials
13/36