Flex JS 18.0-EC Notice D'instruction D'origine page 16

Adjusting the Foot Bevel Angle Adjusting the Foot Bevel Angle
Remove the hexagon wrench from the foot
(see figure G).
To adjust the cutting angle
Turn the tool upside down.
Loosen the hex screw that secures the
foot by the hexagon wrench.
Move the foot slightly forward and tilt it to
the required angle (0° or 45° ) using the
scale (0° or 45° ) that is marked on the
base bracket.
The foot has indents at 0° and 45° (tilt left or
right) for easy angle setting. (see figure H).
Installing and disassembling of Installing and disassembling of
accessories accessories
CAUTION! CAUTION!
Use the cover plate when cutting decorative
veneers, plastics, etc. It protects sensitive or
delicate surfaces from damage. Fit it on the
back of the tool base
Cover plate Cover plate
Installation:
First, the front part of the plate cover is
snapped into the plate. (see figure I)
Then the rear cover of the cover is aligned
and then snapped in.（see figure J）
Disassembly:
Firstly, the two card positions on the
back of the plate cover are removed (see
figure K)
Then the bottom plate is turned down.
After about 30° , the front card position
can be removed (see figure L).
Adapting board Adapting board
Installation:
Insert the adapting board from the front of
the foot about a distance along the slot (a
certain distance from the saw blade).
When using the adapting board for the
first time, insert the saw blade and switch
on, align the foot surface, push the
adapting board, and insert the adapting
board along the slot (see Figure M) while
the saw blade is sawed in the middle of
the adapting board.
A slit makes the adapting board and the
saw blade fit properly to improve the
cutting quality (see Figure N).
When the adapting board is inserted,
there are two limit positions, which
16
correspond to different card positions and
adapt to different needs and improve the
service life.
Disassembly:
When the machine is off, remove the
saw blade and pull out the adapting board
directly (see Figure O).
Transparent Cover Transparent Cover
Installation: Insert the transparent cover from
the front of the machine, snap the gearbox,
and the limit post is aligned with the gearbox
positioning groove. (see figure P).
Disassembly: Open the buckle (see figure Q),
and remove the transparent cover forward.
Vacuum tube Vacuum tube
Installation:
Let the front of vacuum tube toward the
saw blade, insert the middle snap into the
slot on the bottom of the foot (see figure R),
Push the vacuum tube backward, and
align the front screw with the screw hole
on the foot, screw the vacuum tube (see
figure S).
The vacuum tube can be mounted
on either side of the right or left to
accommodate cutting at different angles
of the foot.
Disassembly:
Loosen the screw and push the vacuum
tube slightly forward to remove it directly.
Switching on and off Switching on and off
JS 18.0-EC:
Switching on: push the switch button
forwards and release.
Switching off：push the switch button
forwards and release.
The left and right switch buttons function
are the same.
JSB 18.0-EC:
Lock-off：Lock button to the far left. The
on/off switch is locked and cannot be
pressed. (see figure T1).
On: Lock button moves to the middle
so you can see it on the left and right.
Now the on/off switch can be pressed to
accelerate the machine. (see figure T2).
Lock-on：With on/off switch fully pressed
in and the lock button pushed to the far
right, the on/off switch can be locked to
the "on" position. Press the on/off switch
again to release the lock(see figure T3).
JS 18.0-EC /
JSB 18.0-EC