Bosch GPB 12V-10 Professional Notice Originale page 13

OBJ_BUCH-2915-001.book Page 13 Friday, July 29, 2016 3:30 PM
Construction Site Radio
Audio Operation/Radio
Operating voltage
– for operation with power-
supply plug
– for battery-pack opera-
tion
Rated output of amplifier
(for operation with power-
supply plug)
Reception range
– FM MHz
– AM
1) depending on the battery pack being used
2) limited performance at temperatures <0 °C
Technical data determined with battery from delivery scope.
Power-supply plug
Article number
Input voltage
Frequency
Input current
Output voltage
Output current
Weight according to
EPTA-Procedure 01:2014
Protection class
Assembly
Power Supply of the Construction Site Radio
The power supply of the construction site radio can take place
via the power-supply plug 24 or via a lithium-ion battery 15.
Operation with Battery Pack
Note: Use of batteries not suitable for the construction site ra-
dio can lead to malfunctions of or cause damage to the con-
struction site radio.
Note: The battery pack is supplied partially charged. To en-
sure full capacity of the battery pack, completely charge the
battery pack in the battery charger before using for the first
time.
 Use only the chargers listed in the technical data. Only
these chargers are matched to the lithium-ion batteries
permitted for use in your construction site radio.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
Insert a battery into the battery port 17 in such a manner that
the connections of the battery face against the connections in
the battery port 17, and allow the battery to engage in the bat-
tery port.
Bosch Power Tools
The battery charge-control indicator b appears on the display
GPB 12V-10
as soon as a battery pack with sufficient voltage is inserted
and the construction site radio is not connected to the mains
supply via the power-supply plug 24.
The battery charge-control indicator b indicates the current
V 12
battery pack status. When the battery charge-control indica-
tor flashes, the battery pack must be charged.
V 12
Indication
2 x 5 W
87.5–108
kHz 531–1602
To remove the battery pack 15, press the unlocking buttons
16 and pull the battery pack out of the battery port 17.
Operation with Power-supply Plug
1 600 A00 0..  Observe the mains voltage! The voltage of the power
V~ 100–240
Hz 50/60
Open the protective cap of the 12 V connection socket 23. In-
mA 500
sert the plug-in connector 25 of the 12 V power-supply plug
V= 12
into the 12 V connection socket 23. Connect the power-sup-
mA 1500
ply plug to the mains supply.
 Use only the original Bosch power-supply plug intend-
kg 0.20
/II
After removing the plug-in connector, reattach the protective
cap of the 12 V connection socket 23 to protect against
dirt/debris.
When not using the power-supply plug 24, it can be stored in
the storage compartment of the construction site radio. For
this, disengage the locking latch 21 and open the lid 20 of the
storage compartment.
Inserting/Replacing the Back-up Battery
In order to store the time in the construction site radio, back-
up batteries have to be inserted. Using alkali-manganese bat-
teries is recommended for this purpose.
To open the battery compartment, loosen screw 18 and re-
move battery lid 19. Insert the back-up batteries. When in-
serting, pay attention to the correct polarity according to the
representation on the outside of the battery lid.
Mount the battery lid 19 again and tighten it with screw 18.
Replace the back-up batteries when the time indication e be-
comes weaker and the construction site radio no longer
stores the time.
Always replace all batteries at the same time. Only use batter-
ies from one brand and with the identical capacity.
 Remove the back-up batteries from the construction
Capacity
2/3
1/3
<1/3
Reserve
Battery pack empty
source for the power-supply plug must correspond with
the data on the type plate of the power-supply plug.
ed for your construction site radio. This measure will en-
sure proper operation of the construction site radio.
site radio when not using it for longer periods. When
storing for longer periods, the back-up batteries can cor-
rode and discharge themselves.
English | 13
1 609 92A 2NA | (29.7.16)