Westfalia 307 240 300 107 Instructions De Montage page 11

Installation Instructions:
Electrical System for Towing Hitch
Installing the electrical system
1. Disconnect the ground terminal of the battery.
2. If necessary, remove the following coverings and panels:
•
In the luggage trunk
Covering of luggage trunk bottom
-
Covering of the rear end plate
-
Covering of the right / left trunk side
-
3. Remove the covering for the cable bushing (Fig. 1/2) on the left-hand side of the trunk.
4. Slip the rubber grommet on the cable harness and adapt its length to the cable.
5. Starting in the luggage trunk, lead the cable end through the cable leadthrough to the outside
up to the socket holder plate (Fig. 1/7).
6. Insert the rubber grommet into the cable leadthrough (Fig. 1/2).
Installing the socket
7. Fit the socket gasket and connect the cable harness to the socket housing in accordance with
the pin assignment plan (Fig. 1/7) and push the rubber grommet against the socket.
8. Screw the socket onto the holding plate (Fig. 1/7) using the supplied screws and nuts.
9. Secure the cable harness using cable ties.
Connecting the tail lights
10. Lay the cable end with the right-side marking along the rear end plate to the right-hand tail
light (Fig. 1/8).
11. Unplug the plug of the right-hand tail light and connect it to its counterpart on the cable
harness. Plug the residual plug back into the tail light. Make sure that the plugs lock firmly into
place.
12. Lay the remaining end of the cable harness to the left tail light (Fig. 1/6).
13. Unplug the plug of the left-hand tail light and connect it to its counterpart on the cable
harness. Plug the residual plug back into the tail light. Make sure that the plugs lock firmly into
place.
Connecting the trailer control module
14. Plug the 12-pin plug into the trailer control module (Fig. 1/4).
15. Fasten the trailer control module to the left-hand side of the luggage trunk using some velcro
tape. Make sure it is securely fastened!
16. Connect the brown wires with the eyelet to the vehicle's ground point (Fig. 1/5). If necessary,
set up a conductive connection to the vehicle's ground.
Ford Focus II Turnier 307 240 391 101 – 004 – 41/09 11