Instruction On Mounting And Use; Electrical Connection - BORETTI PLK­-100 Prescriptions De Montage Et Mode D'emploi

GB

INSTRUCTION ON MOUNTING AND USE

Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set out
in this manual. All responsibility,for any eventual
inconveniences, damages or fires caused by not complying
with the instructions in this manual, is declined.
Use
The cooker hood is provided with an upper air exit B for
discharging fumes externally for models including chimney
flue C ( Suction Version A- exhaust pipe not supplied).
If cooking fumes and vapours cannot be externally discharged,
the cooker hood can be used in the recirculating version
F: the installation of 1 active charcoal filter F allows the
recirculation of fumes and vapours through the upper grid G.

Electrical connection

The electrical tension must correspond to the tension noted on
the label placed inside the cooker hood. Place a standards
approved bipolar switch with an aperture distance of not less
than 3mm (accessible) from he contacts.
Operation
4
1: + motor
2: On/Off motor
3: - motor
4: On/Off light
5: Led
Maintenance
Prior to any maintenance operation ensure that the cooker hood
is disconnected from the electrical outlet.
Cleaning:
The cooker hood should be cleaned regularly internally and
externally.For cleaning use a cloth moistened with denatured
alcohol or neutral liquid detergents. Avoid abrasive detergents.
Warning: Failure to carry out the basic standards of the
cleaning of the cooker hood and replacement of the filters may
cause fire risks. Therefore we recommend observing these
instructions.
Anti-grease Filter – must be cleaned once a month, with
5
1
2
3
non abrasive detergents, by hand or in dishwasher on low
temperature and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Charcoal Filter - (only for filter version):
The active charcoal filters F are not washable nor regenerative.
It should be changed every 6 months in normal use.
The active charcoal filters capture unpleasant cooking odours.
Replacing lightbulbs
Warning! Prior to touching the light bulbs ensure they are cooled
down.
Led Light
If the lighting group LED does not work, please contact the
technical service center in order to replace the whole group
.
Caution
This appliance is designed to be operated by adults. Children
should not be allowed to tamper with the controls or play with
the appliance.
Do not use the cooker hood where the grill is not correctly fixed!
The suctioned air must not be conveyed in the same channel
used for fumes discharged by appliances powered by other than
electricity. The environment must always be adequately aerated
when the cooker hood and other appliances powered by other
than electricity are used at the same time. Flambé cooking with
a cooker hood is prohibited. The use of a free flame is damaging
to the filters and may cause fire accidents, therefore free flame
cooking must be avoided. Frying of foods must be kept under
close control in order to avoid overheated oil catching fire.
Carry out fumes discharging in accordance with the regulations
in force by local laws for safety and technical restrictions.
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the documents
accompanying the product, indicates that this appliance may not
be treated as household waste. Instead it shall be handed over
to the applicable collection point for the recycling of electrical and
electronic equipment. Disposal must be carried out in accordance
with local environmental regulations for waste disposal.
For more detailed information about treatment, recovery and
recycling of this product, please contact your local city office,
your household waste disposal service or the shop where you
purchased the product.
In case the remote control has to be changed, the electronics
must be adjusted on the frequency of the new remote control as
follows:
1) disconnect the hood,
2) connect the hood again holding the light key pressed,
3) after the lights of the hood are on, release the light key and
press the motor key within 5 seconds.
1 2