Assembly; Declaration Of Conformity - Wiha SPEEDE Guide Rapide

ASSEMBLY

Declaration of Conformity

We declare under our sole responsibility that the product described under "Technical Data" is in conformity
with all relevant provisions of the directives 2009/125/EC (Regulation 1194/2012), 2011/65/EU, until 19
April 2016: 2004/108/EC, from 20 April 2016 on: 2014/30/EU, 2006/42/EC including their amendments and
complies with the following standards: EN 62841-1, EN 62841-2-1, EN 62841-2-2, EN 50581.
Technical file (2006/42/EC) at:
Wiha Werkzeuge GmbH
Obertalstraße 3-7
D-78136 Schonach
Wilhelm Hahn
Geschäftsführer / Director
Wiha Werkzeuge GmbH
Obertalstraße 3-7, 78136 Schonach
13.10.2017
Assembly
Battery Charging
Only use the charger supplied in the delivery package.
This is the only charger suited to the Li ion battery used in your screwdriver.
Note: The battery
7
using it for the first time to ensure it delivers optimum performance. The Li ion battery
against complete discharge during use. The speedE is switched off by a protection circuit if the battery
low: The electric assisted screw-driving no longer works and the speedE can now only be used as a normal
screwdriver.
Fitting/replacing the battery
Open the end cap 8
battery 7 from the screwdriver handle
handle 6 . Ensure the battery
the end cap 8 on the speedE, turning it in a clockwise direction.
Note: If the light 4 flashes, it indicates that the speedE battery is low (<20%). The electric assisted
screw-driving will still work when the charge level is at 20%. If the charge level continues to fall, only the
light 4 will work to indicate that the battery
23
is partially charged when delivered. Fully charge the battery
by twisting in an anti-clockwise direction. To change the battery, remove the empty
6 . Then insert the charged battery
7 pole terminals are in the right position („-" in the end cap
7 is empty.
7 in the charger before
7 is protected
7
7 into the screwdriver
8 ). Replace
is