I General; Warnings; Installation; Preliminary Indications - Galvamet VAPORE Instructions Pour L'installation, L'utilisation Et La Maintenance

I GENERAL

Exhausting cooker hood. The equipment is constructed under European Standards and with the requirements included
in the following Directives: 2006/95EC (Low Voltage Directive), 2004/108 (Electromagnetic Compatibility).
The present instruction manual is an integral part of the appliance itself, therefore it must be carefully kept and
ALWAYS accompany it, even in case of its assignment to another owner or user or in case the cooker hood is moved to
another installation plant.
The Manufacturer strives for continuous improvements. For this reason, the text and illustrations in this guide may change without notice.
II WARNINGS
Make sure that the voltage (V) and frequency (Hz) indicated on the data plate inside the unit match those available at
the installation site. Any eventual adjustment to the electrical system, which may be necessary to install the cooker
hood, must be carried out only by competent people.
Any repair carried out by no competent people may cause damages.
For any repair or needed technical support refer to a Technical Assistance Centre, authorized to carry out the
replacement of the spare parts. Always make sure that all the electrical parts (lights, exhaustion unit) are disconnected
when the appliance is not in use. By storms take off the main switch of the house electrical system.
The use of the cooker hood must not be other than the use of exhausting units for cooking damps on domestic kitchens.
The manufacturer does not accept any liability for damages caused by people, animals, or things, by installation and
maintenance mistakes, or by any illegitimate use.
We remind that the use of products functioning with electrical energy implies the observance of some essential security
rules, as follows:
•This equipment is not intended for people (children included) with reduced mental or motor capacities, with lack of
experience or knowledge, unless they are supervised or unless a person responsible for their security, gives them
instructions regarding the use of the equipment. Children must be supervised to be sure that they do not play with the
equipment.
•Any cleaning action is forbidden if the appliance hasn't been disconnected from the main power supply and if the main
switch of the house electrical system is not off. If cleaning is not carried out according to these instructions, a fire may
break out.
•Do not pull, take off, or twist the cable coming out from the appliance, even though this has been disconnected from
the main power supply.
•Do not sprinkle or throw any water directly on the appliance.
•Do not stick any sharp tool inside the exhausting holes and into the air discharge.
•Do not take out the filters to reach the internal sides of the appliance in case the main switch of the house electrical
system is not off.
•Do not singe or flambé directly underneath the cooker hood. Take particular care when frying to ensure that the oil
does not catch fire.
•It is forbidden to use the hood as a support surface unless it is expressly indicated.
•Only use the fixing screws supplied with the product for installation.
CAUTION: Accessible parts may become hot when used with cooking appliances.
III INSTALLATION
III.1 Preliminary Indications
Carefully read the guide before installation and use of the appliances.
The installation requires safety equipment and a range of tools as per Fig. 3.1.1
With the hood correctly installed, the minimum distance between the wall unit and the support surface of the cooking
containers in a gas hob must be at least 62 cm.
If the mounting instructions of the gas hob indicate a wider distance, respect it.
With the hood correctly installed, the minimum distance between the wall unit and the induction hob must be at least
50 cm. It must not be superimposed on stoves with an upper radiating plate.
Respect all the air discharge regulations. The air must not be discharged in a pipe used to discharge exhaust fumes
produced by gas-fed equipment or fuel-fed equipment.
The room must be adequately ventilated when the hoods is used together with other gas or fuel types of equipment.
The hood is equipped with all the necessary fastenings for its installation, which are suitable for most surfaces. Verify
that the installation surface is strong.
Installation must be carried out by qualified installers according to present regulations.
9
EN