Installing - Goobay 39513 Mode D'emploi

4.2

Installing

Risk of injury by stumbling and falling
• Place, install and transport product, product ts and accessories
in a safe way.
Injury by cutting
• Do not touch the edges of the rotor.
The rotor is sharp-edged.
Fig. 11: Mounting Base
Fig. 12: Mounting rear part protective grills
1. Loosen the L-fixing screw (4) from the
2. Unscrew them counterclockwise.
3. Remove the washer (5) from the
4. Place the insert in the base as shown in
5. Place the stand on the base. Fig. 11 c).
The stand must slide into the specified
recess.
6. Turn stand and base upside down.
The holes in the base and stand must be on
top of each other.
7. First place the washer on the hole in the
8. Insert the L-fixing screw through the washer
9. Tighten the L-screw clockwise. Fig. 11 d).
10. Turn the stand base unit upside down
11. Unscrew the 4 Phillips screws (6) from the
12. Push the rear protective grille (7) with the
The eyelets in the protective grille (12) must be
flush with the holes (13) in the engine block.
Fig. 12 a).
13. Insert the 4 Phillips screws through the
14. Tighten the Phillips head screws
stand.
Fig. 11 a).
stand (3).
Fig. 11 b).
base.
and the hole in the insert and stand.
again.
engine block by turning them counter-
clockwise. Fig. 12 a)
handle upwards onto the motor axis (14).
eyelets in the protective grille and into the
holes of the engine block (13).
clockwise.
17