Safety Tips - Vogue P088 Mode D'emploi

UK

Safety Tips

• Whilst all care has been taken to remove sharp edges, care must be taken when cleaning or handling
the basin to prevent risk of injury from exposed metal edges.
• Remove all protective film from the surfaces of the basin, taking care to avoid scratching the surfaces.
Assembly
Place the basin face down on the floor.
1.
Attach the basin (i) to the rim (ii) using the four small screws (iii) and a nut/washer (iv) for each.
2.
[A].
Attach the plug unit (v), connecting the plug chain to the long screw (vi) (see 'Fixing the Plug Unit').
3.
Fix the hand basin to the wall using suitable fixings, (not supplied).
4.
WARNING: Ensure the mounting substrate is suitable and can support the weight of the
basin when full.
Fixing the Plug Unit
7
6
5
4
3
2
1
Insert the plug unit as shown. Do not overtighten!
1.
Connect the unit to the drain outlet with suitable pipework.
2.
Note: Consult a qualified plumber if unsure of suitable connections.
Attach the plug chain to the long bolt and then attach the bolt to the basin with the final nut and
3.
washer.
Cleaning
• Clean the basin regularly using a cleaning agent suitable for use with stainless steel.
• Always remove cleaning agent residue. This can discolour the surface of the basin.
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of VOGUE.
Every effort is made to ensure all details are correct at the time of going to press, however, VOGUE reserve the
1
Basin
right to change specifications without notice.
Number Description
1 1¼'' Waste Body
2 Rubber Seal
3 55mm P.E. Washer
4 80mm Stainless Steel
Waste Flange
5 75mm x 6mm Metal
6 1½'' Waste Plug
7
Screw
Chain