iComfort ic7000 Manuel D'utilisation page 4

3)Remove the leg rest carefully from the box
4) Remove all other materials from the box including the pad, pillow, seat cushion, remote control, remote control
holder and the support power cord.
Step 2: Connect the chair and return it to its upright position
1. Connect the provided AC power cord to the control box at the back of the chair.
2. Connect the chair to an AC wall outlet.
3. Press on the main power switch on the control box. The backrest will go up and the leg rest down.
4. Press on the main power switch on the control box to deactivate the chair. And disconnect the
power cord from the AC wall outlet to start the leg rest installation.
Step 3: Leg rest installation
1. Place the rear of the leg rest close to the front of the massage chair.
2. Plug the pine-leaf pin on the leg rest connecting rod. Pull the shaft and the two shaft sleeves out from the
connecting rod hole.
3. Raise the seat front connecting rod and insert the two shaft sleeves from the two sides of the connecting rod
hanger into the holes