Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PURPOSE:
the workshop lamp is a portable source of light. light is emitted by
energy-saving led diodes which, unlike conventional incandescent lamps,
are resistant to mechanical impact, do not heat up the lamp fitting and offer long life
time. The lamp is to be used indoors. It works perfectly during inspections, repairs of
cars and other machines. The workshop lamp is equipped with a practical and useful
rotating hook for hanging it in a suitable place; the lamp is waterproof, dust proof and
chemical proof.
CHARGING BATTERY
When the LED diodes start to darken or flash, it means that the battery will soon be
discharged. to recharge it, take the following steps:
-
put the charger cord plug into the socket in the lamp enclosure.
-
connect the charger to the 100-240V ac main socket or a 12V dc car
socket.
-
connect the lamp to the charger - the charging indicator light on the lamp (the
red led diode) should go on informing that the charging process has
started.
-
the charging control light (a led diode) will be on during the whole
charging process and then the led diode will change its colour to
green, informing you that the battery has been fully charged.
-
after charging, pull the charger out of the socket. then, disconnect the
lamp from the charger.
THE BATTERY SHOULD BE CHARGED WHEN THE AMBIENT
TEMPERATURE IS WITHIN THE RANGE OF 4° C- 40° C.
8
Publicité
Table des Matières
