Fitting; Initial Set-Up - Velux KLF 100 Notice D'utilisation

Fitting

1
Remove cover.
2
Decide position of interface/repeater
unit.
Note: Check that the interface/re-
peater unit can operate the relevant
products from the chosen position
before final fixing.
3
Connect interface/repeater unit to
power supply. Do not replace cover
until the entire installation process is
completed.
The display appears automatically
when the mains power is switched on.
After a short time, menu item
A
displayed.
10 VELUX
A B C D E F G H
LANGuAGE
Dansk
English
Deutsch
is
Enter Back
ENGLISH

Initial set-up

A Language
1
Press to highlight your language.
Press "Enter" to confirm your choice.
2
The display shows that the language has been saved.
After a short time, menu item
B
B Function
The interface/repeater unit (indicated as "Interface") is
used when products are to be controlled with external
control devices that are not compatible, eg intelligent
building installations, sensors and standard wall switches.
1
Press to highlight "Interface".
Press "Enter" to confirm your choice.
2
The display shows that the function has been saved.
After a short time, menu item
C
Note: "Repeater" is used for extending the operation
range of remote controls in the system, see section
Function as a repeater unit.
"Reset system" is used for deleting all settings and reset-
ting the interface/repeater unit to its factory settings.
A B C D E F G H
LANGuAGE
Dansk
English
Deutsch
Enter
INFORMATION
Language saved
is displayed.
A B
Interface
Repeater
Reset system
Enter
INFORMATION
Function saved
is displayed.
ENGLISH
Back
Back
C D E F G H
FuNCTION
Back
Back
VELUX 11