Setting Of Position; Position Up; Position Down - Velux KLF 100 Notice D'utilisation

Setting of position

F G Positions UP and dOWN
Setting of position is used to run products to a position
between 0% and 100% at intervals of 10%. As default
(factory setting) the products will travel to maximum top
or bottom position.
Position table
Entry
Default 0%
Blinds and shades Up
Skylight Open
The position indication for VELUX products corresponds
to the display information on a VELUX remote control.
This applies to all product types except Skylight. You are
therefore recommended to use the position table when
setting the position. Always check the position settings
when the installation of the interface/repeater unit has
been completed.
Note: You can also choose manual operation. In this case,
the products will only be activated as long as the external
control device is active.
20 VELUX
100%
Down
Closed
A B C D E F

POSITION DOWN

90 %
100 %
Manual
Enter
ENGLISH
F

Position UP

1
Press
Press "Enter" to confirm your choice.
2
The display shows that the position has been saved.
C
After a short time, menu item
G Position dOWN
1
Press
Press "Enter" to confirm your choice.
2
The display shows that the position has been saved.
After a short time, menu item
G H
Back
to choose the required position.
G is displayed.
to choose the required position.
H is displayed.
ENGLISH
A B C D E F G H
POSITION uP
0 %
10 %
20 %
Enter Back
INFORMATION
Position saved
Back
A B C D E F G H
POSITION DOWN
100 %
90 %
80 %
Enter Back
INFORMATION
Position saved
Back
VELUX 21