Fixing The Rotation To The Front; Detaching The Plasma Display From The Stand; Specifications - Pioneer PDK-1013 Mode D'emploi

Fixing the rotation to the front

Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
Use a screw that has a nominal
diameter of 4 mm (3/16 inch)
and length from 20 to 30 mm
(13/16 to 1-3/16 inch) to fix the
rotation to the front.

Detaching the Plasma Display from the Stand

To remove the plasma display from the stand, be sure
to always follow the procedure described below to
prevent accidents.
Caution
1
First, confirm that the forward/backward
inclination anchor bolt is securely
tightened.
2
First clear a space on a flat floor etc. where
you can lay the plasma display flat, then
lay a sheet to protect it from scratches or
other damage.
3
Remove the speakers.

Specifications

External dimensions
Weight
• The above specifications and exterior may be modified without prior notice to improve the product.
10
En
20 to 30 mm
(13/16 to 1-3/16 inch)
577 (W) x 249.5 (H) x 380 (D) mm (22-23/32 (W) x 9-27/32 (H) x 14-31/32 (D) in.)
[When using the support columns]
10.5 kg (23.2 lbs)
4
Referring to steps 2 and 3 in "Attaching
the Plasma Display" (Page 5.), remove the
installation screws (4 screws).
Note
Do not remove the screws (M8 x 16mm: silver) by
procedure 2 in Page 4. The support columns might slip
out of place and fall over.
5
Holding the plasma display by its handles
and from the bottom, lift the display verti-
cally.
6
Place the plasma display slowly onto the
sheet laid out in step 2 with its screen
facing downwards.
Note
When reattaching the plasma display to the stand, be
certain that the left/right support columns are set at the
same angle.