Using The Timer; Updating Firmware - Hatco Rapide Cuisine IRNG Série Manuel D'installation Et D'utilisation

OPERATION

Using the Timer

A timer is available on the H Type Induction Range.
1. Touch the Button on the control
panel to access the Timer Screen.
• The top of the screen shows
the timer highlighted by a white
outline, and the bottom of the
screen shows the Power setting.
2. Set the timer by turning the Control Knob within three
seconds.
• After the timer is set, the white outline drops to outline the
Power setting.
3. Adjust the Power by turning the Control Knob.
• When the timer reaches zero, the
timer flashes between "DONE"
and "0:00:00". The Power setting
drops to "0".

Updating Firmware

Use the following procedure to upload firmware updates to the
Induction Range from an external USB drive.
NOTE: For the latest firmware updates, cooking tips, and
more, go to the Hatco Induction Range website:
www.hatcocorp.com/rapide_cuisine
1. Push the Control Knob to start the Induction Range.
• The Power Control screen appears showing a bar graph
and a percentage of power setting.
2. Push and hold the Control Knob for
approximately 6–8 seconds.
• A password screen will appear.
• To enter the 3-digit password
"248", turn the Control Knob to
the first number, then press the
Control Knob to select. The highlighed square will move
to the next digit. Continue entering the password until
complete.
• The Firmware Update screen
will appear.
3. Insert the USB drive into the USB
port.
• The USB port is either on the
bottom or on the right side of the
unit.
Ceramic
Glass
Cooking
Surface
Timer
Button
H Type Countertop Model
4. Turn the Control Knob to highlight UPDATE, then push the
Control Knob to start the update.
• A screen will appear to indicate the update is in progress.
• When the update is complete, the Welcome screen will
appear for a few seconds showing the new firmware
version, and the unit will shut down.
NOTE: To exit the Firmware Update screen without performing
an update, turn the Control Knob to highlight EXIT, then
push the Control Knob to return to the Power Control
screen.
8
English
USB Port
Control
Power/Control
Display
Knob
Form No. IRNGHM-0117