Door Reversal Instructions - Danby Designer DCRM31WDD Guide D'utilisation Et Soins De Propriètaire

DOOR REVERSAL INSTRUCTIONS
This refrigerator has been built with the door hinges on
the right. if you wish to change the opening direction,
follow the instructions below:
1. Remove the small plastic cover (7) and the plastic
hinge cover (6) on the appliance top to disassemble the
worktop.
2. Remove the two screws (1) that hold the upper hinge
(5) (right side) to the frame. Take away the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent it
from scratching.
4. Remove the two screws (8) that hold the lower hinge (2)
and make sure to remove the lower hinge (2).
5. Remove the left front leg (4) and transfer it to the right
side.
INSTALLATION INSTRUCTIONS
FIG.1
Represents position of components prior to
FIGURE 1
door reversal.
Represents position of components after door
FIGURE 2
reversal.
6. Before placing this lower hinge (2,) remove the bolt-pin (9)
and reverse the direction of the lower hinge (2). Then install
the lower hinge (2) onto the left side of the lower frame with
two screws. (8)
7. Insert the bolt-pin (9) to the lower hinge (2.)
8. Set the door to its place making sure the door seat is at
the lower hinge (2.)
9. While holding the door in the closed position secure the
upper hinge (5) in the top frame of the left side with
two screws (1.) Please remember to not tighten the two
screws (1) until the top of the door is levelled with the
top cover.
10. Install the worktop onto the top of the cabinet with plastic
hinge cover (6) and attach the small plastic cover (7.)
FIG.2
5