Care - Dräger RH 600 Notice D'utilisation

Care

Care
Shutdown
Switch off the device(s). Disconnect the power plug.
Cleaning/disinfecting
Allow the radiant heater to cool down for about
30 minutes before cleaning/disinfecting.
Do not allow any liquids to enter the apparatus.
Wheeled stand;
Infant radiant heater, exterior:
Remove any visible impurities with a disposable cloth
soaked in washing-up liquid.
Wipe-disinfect all surfaces.
Wait the specified time for the detergent to act and
then wipe off with a damp cloth and dry.
Only use the recommended detergents and disinfectants.
Unauthorised products, e.g. alcohol, may cause stress
cracking of the acrylic glass and "macrolon" material.
Use only preparations classified as "surface
disinfectants" for disinfecting. For material compatibility,
we recommend preparations based on
– aldehydes
– quaternary ammonium compounds.
Due to possible damage to materials, the following
preparations are unsuitable:
– halogen-releasing compounds
– strong organic acids
– oxygen-releasing compounds.
For users in the Federal Republic of Germany, we
recommend the use of disinfectants listed in the current
DGHM list (DGHM = German Society for Hygiene and
Microbiology).
The DGHM list (published by mhp Verlag GmbH,
Wiesbaden) also specifies the active basis of each
disinfectant.
For countries where the DGHM list is unavailable, we
recommend products based on the above active
compounds.
48
For example, the following wipe-disinfectants may be
used:
Bacillotox Bode, Hamburg
Incidur Henkel Hygiene GmbH,
Düsseldorf
Dismozon pur Bode Chemie GmbH & Co.
Sekusept-Pulver Henkel Hygiene GmbH,
Düsseldorf
Follow the Instructions for Use provided by the detergent
manufacturer.
Before next use
After wipe-disinfection, operate the fully assembled
unit for a few hours without the patient, in order to
eliminate any disinfectant residues.
Set the radiant heater to heat level 5 in »Man« mode.
Check that the unit is ready for operation:
see page 34.