Errors - 3M Bair Hugger 370 Manuel D'utilisation

Errors

Error
Error Code Description
Code
E-1
E-3
E-4
E-5
E-6
E-7
E-8
E-9
E-10
E-11
E-12
E-13
E-14
E-15 Heater temperature sensor is out of range
E-16 Skin and heater temperature sensor difference is too great
E-17
E-18
E-20
E-21
E-22
E-23
E-24
E-25 Broken skin or heater temperature sensor
Sensor and/or Cable Error Codes
Broken heating element in sensor
Corrupted sensor data
No uses remaining on sensor
No time remaining on sensor
Broken heating element in sensor
Broken heating element in sensor
Error writing trend data
No time remaining on sensor
Unknown sensor
Corrupted sensor data
Corrupted sensor data
Time limit exceeded in calibration
Skin temperature sensor is out of range
Broken heating element in sensor
Corrupted sensor data
Sensor authentication error
Sensor checksum error
Unknown sensor type
Sensor and hardware data mismatch
Skin temperature sensor is out of range
Troubleshooting Steps
E-xx
Step 1. Disconnect and reconnect
temperature sensor
Step 2. If error persists, restart unit by
unplugging power supply cable
Step 3. If error persists, replace
temperature sensor
Step 4. If error persists, replace sensor
cable
If error persists, contact your 3M
representative
Please do NOT unplug the connection
between the sensor cable and the
control unit (mini-din plug) when
troubleshooting Steps 1, 2, &3.
11