Remote Control - AVer VC520 Pro2 Mode D'emploi

Remote Control

Camera Select
Camera Directional
Control
OSD Menu*
SmartFrame
Zoom In/Out
Preset
Brightness -
Call/Answer
*Not supported for VC520 Pro2
AAA Batteries (required)

Preset ( ): The Preset button on the

remote serves 2 functions.
To Save a Preset - Move camera to desired
position. Press and hold the preset button
until you receive the save message on the
screen. Select preset position button 0-9 to
store the current camera position. Repeat
steps if needed.
To Load a Preset - Press the preset button
and preset position button 0-9 to load a saved
camera position. Repeat steps if needed.
Press and hold the number button "

second to turn on or off the WDR function.
Press and hold the number button "

second to turn on or off the SmartFrame
function.
Enter*
" for 1
" for 1
English-5
Press and hold the number button "

for 1 second to enable or disable RTMP
streaming function.
Press and hold the number button "

for 1 second to force camera to enter
sleep mode. This will end any video
streaming. To wake up the camera,
press the button or any directional button
for 1 second. This mode is not functional
while USB streaming is on.
Camera Select (

only have one camera and do not need
to adjust any setting, the default is
camera 1. If you press camera 2 or 3 on
the remote control, you will find your
remote can't control your camera. In this
case, please press camera 1 on your
remote again.
SmartFrame (

to switch the SmartFrame function
among Manual Framing/Auto Framing/
Preset Framing modes. A message (as
figures shown) will display on the screen
to indicate the mode.
[Note] SmartFrame deploys face and
body detection technology. People
wearing masks and side facial profiles
can still be detected. The maximum
detection distance is 7-10 meters.
Set up preset points in advance (Only for
Preset point 1-9. Preset 0 is for home
position).
): If you
): Press for 1 second
"
"