Setting The Time - Hama 137289 Mode D'emploi

5. Starting up/entering the electricity price
(euro/kWh)
Note
• If the energy cost meter cannot be started, then
press the reset button (5) for a few seconds.
• The rechargeable battery is charged during
operation.
• The internal rechargeable battery will discharge
if the timer switch is not used for longer periods
of time. Plug the energy cost meter into a mains
plug for approx. 24 hours every 3 months to
charge the internal rechargeable battery.
Press the FUNC button to view the following displays
in succession:
• VOLTac: mains voltage, mains frequency and time
are displayed
• AMP: current, power factor and time are displayed
• WATT: output, power factor and time are displayed
• WATT max: maximum output is displayed
• kWh: kWh consumed, power factor and time are displayed
• TOTAL PRICE; TOTAL ON TIME: total price and usage
duration are displayed
• PRICE1: Price 1 is displayed only if a value in cents /
kWh has already been entered for PRICE 1
• PRICE2: Price 2 is only displayed if a value in cents /
kWh has already been entered for PRICE 2

5.1 Setting the time

• Press the FUNC button until CLOCK is shown in
the display.
• Press the SET button and use the UP button to set
the day of the week.
• Press the SET button and use the UP button to
set the hour.
• Press the SET button and use the UP button to set
the minutes.
• Press the SET button to save your settings.
• Press the UP button to choose between 12-h and
24-h mode.
5.2 Setting price
If you have two different electricity prices with your
electricity provider (e.g. normal tariff and night tariff), you
can set both on the energy cost meter and also the period
(day / s of the week and time) for which the respective
tariff applies. If you only have one electricity price that
applies around the clock, you only need to enter the
electricity costs for price 1. The days of the week, the time
and the dates for price 2 should then be left blank.
• Press and hold the FUNC button for a few seconds
until COST/Kwh is shown in the display.
• Press the SET button to set Price 1. Use the SET
button to select the digit you would like to enter.
• Enter the required value using the UP button.
• Press the SET button and use the UP button to set
the corresponding days of the week.
• Press the SET button and use the UP button to set
the corresponding time.
• Press the SET button to save your settings.
• After setting Price 1, press the FUNC button to
set Price 2.
• If you only have one electricity price, do not enter
any values for price 2
• Then repeat the steps described above
• After setting Price 2, press the FUNC button to set
the maximum overload value.
• Press the SET button and then select the digit you
would like to enter.
• Enter the required value using the UP button.
• Press the SET button to save your setting.
• Press and hold the FUNC button for a few seconds
to return to the standard display.
6. Measurement
Note
• Precise measurement results even for small
appliances.
• The voltage and power draw of the connected
devices may not exceed 230 V and 3680 W.
• Note the information specified on the name-
plate(s) of the connected device(s).
• If you connect an electrical appliance that draws
more than 3680 W, then the display shows
OVERLOAD.
• It is advisable to measure the power consump-
tion of a device for an extended period of time
and then calculate its annual consumption.
4