Installation; General Instructions; Installation In Boiler; Place Of Installation - Ferroli SUN M 50 Mode D'emploi, Installation Et Entretien

2. INSTALLATION

2.1 General Instructions

This unit must only be used for its intended purpose. Compatibly with its performance, characteristics
and heating capacity, this unit can be used with water, steam or diathermic oil boilers, and with other
users expressly provided for by the relevant manufacturer. Any other use is deemed improper and
therefore hazardous.
Opening or tampering with the unit's components is not allowed (except for the parts requiring servicing);
do not modify the unit to alter its performance or intended use.
THE BURNER ONLY WORKS WITH FERROLI GAS TRAINS.
If the burner is completed with optionals, kits or accessories, only use original products.
BURNER INSTALLATION AND SETTING MUST ONLY BE CARRIED OUT BY QUALIFIED
AND SPECIALISED PERSONNEL, ACCORDING TO ALL THE INSTRUCTIONS GIVEN IN THIS
TECHNICAL MANUAL, THE CURRENT PROVISIONS OF LAW, THE PRESCRIPTIONS OF
NATIONAL AND LOCAL STANDARDS, AND THE RULES OF PROPER WORKMANSHIP.

2.2 Installation in boiler

Place of installation

The room where the boiler and burner are installed must have openings to the outside as required by
current regulations. If there are several burners or exhausters that can work together in the same room,
the ventilation openings must be sized for simultaneous operation of all the units.
The place of installation must be free of flammable materials or objects, corrosive gases, dusts or volatile
substances which, drawn by the fan, can obstruct the pipes inside the burner or the combustion head.
The room must be dry and not exposed to rain, snow or frost.

Fixing the burner to the boiler

34
Burner flange
Ø182
260
fig. 2a
Cod. 35447686 - 04/2008 (Rev. 00)
SUN M50 - M70
Ø225
Ø290
GB