Rotel U685CH1 Mode D'emploi page 36

 ASSEMBLY
o
1. Remove all the parts from the package. Verify all the listed parts are included.
o
2. Insert one end of the aluminum pole into the mop handle. Push the pole fully
inside the handle and tighten it with screw(middle one: Ф4x28mm). (fig.1)
o
3. Insert the other end of the aluminum pole into the top of main body of steam
mop, and tighten with screw(biggest one: Ф6x40mm). (fig.2)
o
4. Insert the mop head into the bottom of main body of steam mop, and tighten
with screw(smallest one: Ф4x6mm). (fig.3)
o
5. Assembly completed. Power cord can be catched by the clip on the aluminum
pole. (fig.4)
▲ Important:
o

1. Please fill the water tank with water before using. Verify if water tank is
firmly attached. Firstly attach with the cleaning cloth to avoid the hard mop
head scratching the floor.

2. When assembling your steam mop there may be a little water in or around
the water tank. This is because we test all our steam mops strictly before you
buy them, so that you can get a qualified steam mop.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use