Sony 7011458 Mode D'emploi page 2

GB
In-car Cradle Instruction Manual
For use with the PSP™ (PlayStation
Precautions
• Before using this product, carefully read this manual and retain it
for future reference. Also refer to the instructions for your PSP™
(PlayStation Portable) system.
®
• Make sure you install the cradle securely in accordance with these
installation instructions. Attach the PSP™ system to the cradle and
ensure that the cradle is firmly mounted on the windscreen.
• Do not use with products other than the PSP™ system.
• Never disassemble or modify this product.
• Do not throw or drop this product, or physically damage it in any way.
• Do not install this product over an airbag cover or within the airbag
deployment zone.
• The PSP™ system should never be operated by a driver whilst the
vehicle is in motion.
• Cradle should not obstruct driver's normal line of vision.
• Cradle should be positioned to enable driver to view PSP™ system
without taking their eyes off the road for a long period of time.
• Nothing in this manual shall affect any statutory rights and remedies the
consumer may have in respect of this product in any way.
• Insert and remove the PSP™ system carefully from the cradle to avoid
scratching or damage. The spacer inserts must only be used when inserting a
PSP-2000 series system into the cradle. Do not attempt to insert a PSP-1000
series system into a cradle with the spacer inserts in place.
Contents
A Pedestal
B Cradle
C Spacer inserts
A
Installing on the Windscreen
Step 1. Push the pedestal suction cup (1) firmly to the windscreen. Flip the
lever (2) up to secure the suction cup.
1
Portable) system and GPS receiver
®
B
C
2
Pedestal and T-Tab Head Instructions
Step 1. Adjust the angle of the arm by loosening the adjustment knob (3).
Step 2. Adjust the angle and rotation of the pedestal head by loosening the
tightening knob (4).
Step 3. Attach the cradle to the T-tab head (5) by inserting the T-tabs into
the T-slots (6).
4
3
Cradle Instructions for PSP-2000 Series
Step 1. Insert the PSP™ system into the cradle by sliding it straight down
until it rests on the support legs (7).
Cradle Instructions for PSP-1000 Series
Step 1. Remove the spacer inserts* (8) by pushing them up until they
detach from the cradle. This creates enough space to accommodate
the PSP-1000 series system.
Step 2. Follow Step 1 of 'Cradle Instructions for PSP-2000 Series' as
outlined previously.
8
*The spacer inserts are designed to enable PSP-2000 series systems to fit securely
in the cradle. The spacer inserts must only be used when inserting a PSP-2000 series
system into the cradle.
For contact details please visit www.playstation.com
© 2008 Sony Computer Entertainment Europe.
" ", "PlayStation" and " " are trademarks or registered trademarks of Sony
Computer Entertainment Inc. All rights reserved.
5
6
7