Reggiani ROLLIOS Guide D'installation page 10

ROLLIOS | ENG |
www.reggiani.net
INSTALLATION/REPLACE-
MENT OF LAMPS
Turn the electricity off at the
mains and follow the instruc-
tions below.
• For Metal halide lamps MT/UB G8.5
2
20/35W – G12 20/35/70W;
A low voltage halogen lamps HS-G/UB GY
6.35 60Wmax
Remove the protective reflector by turn-
A
ing it anticlockwise (fig.2);
insert/replace the lamp (with one of
B
equal rating as the ballast, see rating
plate);
re-engage the refl ector correctly by
C
turning it clockwise;
N.B. Always check the safety glass for
2
intactness and for perfect fitting on the
B
locking ring.
Warning: when the lamp is dying, i.e. the
luminous flux is decreasing, the lamp
must be replaced to prevent serious dam-
age to the control gear.
2
C
010
• For LEDs:
The projectors are supplied with the LED
already installed.
Remove the blue protective film before
switching on the LED (fig.3
A
Do not touch the LED; in particular, avoid
the use of pointed tools which could
otherwise damage internal connections.
The reflector twist-lock fixing system
fig.3
(present on most products equipped
B
with the LED) allows the adjustment of the
beam from narrow to wide or Wall Washer
Mira (refer to the catalogue or access the
product datasheet on the website:
www.reggiani.net/reference
corresponding accessory).
Arrange the retainer tabs in the optical
compartment. Press and turn the refl
ector clockwise until it snaps into place
fig.3
C
The Wall Washer Mira reflectors enable
additional adjustment of the elliptical
beam by rotating the shield. There is no
provision for replacing the light source on
LED projectors. If any malfunction occurs,
contact Reggiani Spa Illuminazione to re-
place the luminare.
).
for the