Reset - Factory Settings - D+H Ventic-Solar Notice Originale

Connect TMS drives
Start programming mode:
Drive 1
5
>
Sec.
5
Sec.
Leave programming mode:
Drive 1
If the assignment is deleted by RCR 11 (Level 3, BDT 010-RC = Level 2),
the TMS connection is also deleted.
The drive must be reconnected.

Reset - Factory settings

16/36
Ventic-Solar
5
Sec.
1x
Programming mode finished
10
>
Sec.
English
TMS function
Whenever two drives are operated on a single
sash,the tandem safety function (TMS) can be
used.This function connects the cut-offs of the two
drives in such a way that if one drive is cut off due to
overload, the other drive will similarly be cut off.
Drive 2
2
>
Sec.
All assignments and settings
will be deleted!
99.824.79 1.3/06/13