Use And Technical Description - Altrad PR0 900 Manuel De L'opérateur

• There is a stop switch on the handle of P900 Power Trowel for stopping the machine against any dan-
gers running. The machine runs when stop switch is hold in closed position by the operator. Releasing
the stop switch will stop the machine.
• If the operator accidentally loses control of the handle or releases the stop switch, engine will stop run-
ning however the hadle will make 1-1,5 turns with the existing energy of the machine (see above figure)
KEEP EVERYONE AT A SAFE DISTANCE, AWAY FROM THE SAFETY ZONE
• When loading and transporting the machine, fasten the machine with its lifting eye properly.
• On a carrier, secure the machine safely to prevent its movement or its rolling over.
• Service must be performed only by qualified service technicians.
• Check the maintenance table to make the periodic maintenance.
• Use genuine spare parts only. The manufacturer does not bear any responsibility for damages arising
from use of non-original spare parts.
• Do not make any service or maintenance without stopping the engine.
• Keep the rotating parts and stationary ring clean.
• Pay extra care while operating the machine on the wet work surfaces. Wet surfaces may cause acci-
dents.
• Be sure the fuel tank is full. Use the recommended gasoline to run the engine from its instruction book.
• Check engine oil levels.
• Turn the engine's stop switch clockwise to the position "I".
• Open the fuel cock.
• Set the speed control lever 1/3 of the way towards the high-speed position.
• If the engine is warm or the ambient temperature is high, close the choke lever half way, or keep it open
fully. If the engine is cold, or the ambient temperature is low, close the choke lever.
• Pull the starter handle slowly until the resistance is felt. Return the handle to its original position and
pull swiftly.
• Allow a longer warm-up period in cold weather temperatures.
Safety Zone
Tranportation
Service
Spécific Safety rules

2. USE AND TECHNICAL DESCRIPTION

Starting procédure
14