Device Description - KRESS 650 SPS Mode D'emploi Original

18 English

3. Device description

Read all the warnings and instruc-
EN
tions before using the equipment.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Device components
1 On/off switch
2 Electronic adjusting dial
3 Dust hood
4 Saw bench
5 Parallel fence (accessory)
6 Tension lever
7 Pendulum stroke adjusting knob
8 Saw blade
9 Suction connection piece ø 35 mm
10 Stop lever
11 Mains cable module
12 Interlock button
13 Chip-flyoff guard (plastic)
14 Sliding block
15 Chip-flyoff guard (steel)
16 Plastic cap (insulated gripping surface)
17 Handle (insulated gripping surface)
Scope of supply
See packaging
Specified conditions of use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ceramic
plates and rubber while resting firmly on the work-
piece. It is suitable for straight and curved cuts
with mitre angles to 45°. The saw blade recom-
mendations are to be observed.
Requirements for the user
The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.
SPS-EN / 0912
Technical data
Jig saw
V~
Nominal voltage
Watt
Input power
Watt
Output power
min
Idling speed stroke
number n
0
min
Standard stroke
range
mm
Stroke height
mm
Cutting capacity,
max. in wood
non alloy steel mm
light metal
Cutting capacity,
max.
°
Mitre cut
kg
Weight
Your power tool is double-insulated
in accordance with EN 60745; For
this reason an earth wire is not
required.
The device is suppressed against radio and TV
broadcasts, in accordance with EN 55014-1 and is
immune to disturbances in accordance with EN
55014-2.
Device description
650 SPS
-1
3200
-1
500...3200
mm
230
650
340
19
110
6
16
45
2,3