KOS Box Kosmic Manuel D'emploi Et D'entretien page 13

KOSMIC Z is a shower cabin that comes in two versions, KOSMIC Z2 and KOSMIC Z1. They differ in their external
dimensions and the number of users. Each version is equipped with various functions that fall into two categories:
functions with automatic control and those with manual control.
Functions with manual control do not require electricity and are controlled entirely from the tap fixture. These
functions enable the normal operations of personal cleaning and are:
• Hand-held shower head controlled by knob A.
• Back jets controlled by knob A.
• Fixed shower head with high flow rate controlled by tap A.
The automatic functions, controlled by the electronics, are:
• Turkish bath
• IDROCOLORE® (optional)
• Radio (optional)
To ensure comfortable use of the KOSMIC Z shower booth, before you start any treatment, make sure you adjust the
water temperature using the thermostatic mixer (8 see the chapter on adjusting the water temperature); check it
with your hand before you wet your body.
ADJUSTING ThE TEMPERATURE OF WATER
The water temperature is controlled by knob B. It has a safety stop of 38°C.
If you want a higher temperature, press latch "C" (figure
to increase the temperature (>38°C) (fig.
USE OF DEVIATOR
KOSMIC Z2
pos. Connection
1 RH and LH back jets
2 RH back jets
3 LH back jets
4 Shower head
5 Manual shower head
USE OF ELECTRONIC KEyPAD "Touch&Go" BOX
To turn the shower cabin on, turn the main ON/OFF switch to "I" as previously shown. LED 1 will then come on.
The shower cabin is now ready for use.
The three buttons on the electronic panel control
three functions:
1 • LED indicator
2 • Not used in this model
3 • Activation of Turkish bath
4 • Activation of IDROCOLORE®
INTRODUCTION KOSMIC Z1 - KOSMIC Z2
USE OF KOSMIC Z1 - KOSMIC Z2 CABIN
).

KOSMIC Z1
pos. Connection
1 Shower head
2 Manual shower head
3 Back and cervical jets
4 Manual shower head
5 Back and cervical jets
) and at the same time turn the knob counter-clockwise

Turn knob A (fig.
in the table alongside.
After choosing the position, raise the knob A (fig.
).

13
) to deviate the water as shown
