Removing The Transport Brackets - Danby Designer DWM5500W Manuel D'utilisation

Removing the Transport Brackets

The washing assembly is blocked with two metal
rods which protects the machine during transport
(fig.1).
• Undo the screws on the rear wall (fig. 2).
• Remove the squares, rotate them 180° and
use them to pull out the rods (fig. 3).
• Disengaged parts may remain at the bottom
since they do not obstruct the operation of the
machine (4 rubber hoses and 4 paper spools).
• Use the enclosed plastic caps to plug the holes
(fig. 4).
Save the brackets: you may need them later.
INSTALLATION INSTRUCTIONS
1
3
2
4
Instructions for Use
7