Pruning Trees - Makita DUC256 Manuel D'instruction

After refilling, hold the chain saw away from the
tree. Start it and wait until lubrication on saw
chain is adequate.
NOTICE: When filling the chain oil for the
first time, or refilling the tank after it has
been completely emptied, add oil up to the
bottom edge of the filler neck. The oil deliv-
ery may otherwise be impaired.
NOTICE: Use the saw chain oil exclusively
for Makita chain saws or equivalent oil
available in the market.
NOTICE: Never use oil including dust and
particles or volatile oil.
NOTICE: When pruning trees, use botanical
oil. Mineral oil may harm trees.
NOTICE: Before the cutting operation,
make sure that the provided oil tank cap is
screwed in place.
WORKING WITH THE CHAIN SAW
CAUTION: The first time user should, as
a minimum practice, do cutting logs on a
saw-horse or cradle.
CAUTION: When sawing precut timber,
use a safe support (saw horse or cradle).
Do not steady the workpiece with your foot,
and do not allow anyone else to hold or
steady it.
CAUTION: Secure round pieces against
rotation.
CAUTION: Keep all parts of the body
away from the saw chain when the motor is
operating.
CAUTION: Hold the chain saw firmly with
both hands when the motor is running.
CAUTION: Do not overreach. Keep
proper footing and balance at all times.
NOTICE: Never toss or drop the tool.
NOTICE: Do not cover the vents of the tool.

Pruning trees

Bring the chain saw body into contact with the
branch to be cut before switching on. Otherwise
it may cause the guide bar to wobble, resulting
in injury to operator. Saw the wood to be cut by
just moving it down by using the weight of the
chain saw.
If you cannot cut the timber right through with a
single stroke:
Apply light pressure to the handle and continue
sawing and draw the chain saw back a little.
When cutting thick branches, first make a shal-
low undercut and then make the finish cut from
the top.
16 ENGLISH
1
2