CGM SUPERPOWER 2200I Manuel D'utilisation page 20

Output, overload indicator, oil warning light:
Under normal operating conditions, the output indicator light (green) will be lit.
If the generator is overloaded, or it has occurred an internal short circuit or a short circuit to the connected
equipment, the output indicator light (green) is off and overload indicator (red) lights up. There is no
output.
If the overload indicator light is lit, first disconnect the device from the generator, check whether the
device is faulty, whether there are problems with the connection line, turn off the power to the device,
confirm which is the reason why device overloaded, when the reasons of the overload have
been resolved, press reset switch on the panel, three seconds after the generator indicator will turn red
to green, the generator begins normal output power.
If you press the reset switch and you wait three seconds but the generator lights do not turn from red to
green, then turn off the engine and please contact an authorized dealer.
If the oil alarm light is lit, the engine will automatically shut down, then check if the oil should be added.
◆ Before connecting the device to the generator, check whether the device is in good condition,
whether the required power exceeds the generator capacity, then connect the cable and start
the generator.
◆ Make sure that the connected devices power switch is on "OFF" position.
Note
20