Warranty Information - EcoSalt BMSC 8 Manuel D'installation Et D'entretien

WARRANTY INFORMATION:

During the warranty period, when an authorised technician is requested to service your
Unit outside company premises, a call - out fee will be charged to cover time
travelling to and from the site and the cost of operating the vehicle. This fee will not
apply if the Unit is returned to the Distributor in your State for repairs. If an authorised
technician is required to service your Unit and it is found that such services are not
covered by warranty, labour charges will apply. Monarch Industries strives to reduce or
eliminate any unnecessary expense by producing this Manual. Experience has shown
that by following this Manual - in particular the section on Trouble Shooting,
approximately 75% of all service calls are unnecessary and the expense and frustration
to clients could have been avoided. We therefore strongly suggest that the owner read
and absorb all information thoroughly. All legitimate warranty claims on your Power
Supply (parts and labour where returned to the distributor) are free for the first 12
months from the date of installation.
IMPORTANT: ALWAYS INSIST ON GENUINE MONARCH POOL SYSTEMS
REPLACEMENT PARTS. If it is necessary to replace the Electrolytic Cell, beware of
"look alikes". Only the Genuine Monarch Pool Systems Cell is designed and warranted
to operate with the Monarch Pool Systems Power Supply.
SERIOUS DAMAGE MAY RESULT TO THE ELECTRONICS INSIDE THE UNIT IF
COPY ELECTRODES ARE USED AND WILL VOID WARRANTY.
TROUBLE SHOOTING:
No Chlorine Production - Check for
1. Main power outlet switched off or Chlorinator not connected to mains supply.
2. Chlorinator fuse blown
3. Dirty Cell
4. Filter needs backwashing
5. Gas Sensor not connected
6. Running times incorrect
7. Main house fuse blown
8. Pump motor faulty
Low Chlorine Production - Check for
1. Dirty Cell - clean if required
2. Filter needs backwashing
3. Not set at correct production level/Cell failing
4. Pool stabiliser too low or Salt level to low
5. pH too high
6. Running times too short
Page 15 of 100 P/N MMAN001FRA-3