Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Peel off backing of double-sided tape. Align the duct
assembly screw hole to the existing screw hole on left side of
microwave oven, and attach the duct assembly to the oven.
Press down firmly on ducts, then fasten with existing screw.
A
A. Existing screw
Anti-Tip Bracket Installation
1. On cutout floor, use template to mark hole centers for anti-tip
bracket. Be sure to align the centerline of template to
centerline of cutout floor.
(Dimensions as shown are not to scale.)
¹⁄₂
A. 1
" (3.81 cm)
B. 3" (7.62 cm)
C. 16" (40.64 cm)
2. Drill 2 holes for anti-tip bracket. (Use ⁵⁄₆₄" drill.)
3. Install anti-tip bracket onto cutout floor using two ¹⁄₂" screws.
A
B
¹⁄₂
A.
B. Anti-tip bracket
4
A
B
C
D
E
F
D. Cutout opening
E. Cutout floor
F. Centerline
" screws
Microwave Oven Placement
1. Slide microwave oven partway into cutout opening.
NOTE: Bottom bracket must be flat against cutout floor in order
to correctly engage with anti-tip bracket.
A
B
C
A. Bottom duct
B. Anti-tip bracket
C. Bottom bracket
2. Plug in microwave oven.
3. Make sure microwave oven is centered within cutout opening
and slide it into place, engaging anti-tip bracket.
4. Drill pilot holes through positioning flange. (Use ⁵⁄₆₄" drill.)
Then install three ¹⁄₂" screws at front of bottom duct.
A
B
C
A. Cutout opening
B. Positioning flange
¹⁄₂
C.
" screws
Publicité
Table des Matières
