Audio Modes - PDP Afterglow NUR Manuel D'utilisation

set uP: Mobile devices
1. To enable Afterglow lighting effects while in mobile mode, first make sure your wireless
transmitter is not plugged in.
2. Press and hold the mute button on your headset to power the headset on. You will see the
headset's lights alternating, indicating that it is searching for a transmitter.
3. to put the headset in mobile mode, press the audio mode button for 10 seconds until you
hear a beep. Your headset is now in mobile mode.
4. Plug the grey 3.5mm cable and plug one end into the Afterglow headset and the other into
the audio output in your mobile device. the microphone capability will be enabled for
phone calls.
5. Adjust the volume as desired on your mobile device.
*note: Your headset's lighting effects can be adjusted while in mobile mode by moving the
lighting switch between modes.
in order to bring your Afterglow headset out of mobile mode, hold down the large mute button
for 3 seconds to power the headset off.
When you power the headset on again, your headset will be out of mobile mode. You will
notice the alternating lights, indicating your headset is searching for a wireless transmitter.

AuDio Modes

aUdio Modes are indicated by tHe voice cUes tHat tell yoU wHat Mode
yoU are in.
PUre aUdio: Pure audio offers a well-balanced and wide ranged audio experience that
enables you to hear the game exactly as the game developers intended with no
extra enhancements.
bass boost aUdio: For those who prefer the extra kick on low end, this mode boosts
the low frequencies and adds the extra depth to your explosions without sacrificing the
undistorted, clean audio.
english lighting Modes
tHe aFterGlow wireless Headset inclUdes tHree liGHtinG Modes:
ManUal liGHtinG: in this mode, the Afterglow lights will be set to blue by default. You can
transition the colors by pressing and holding the mode button. upon release the ear cup leD
will set at the desired color.
the Afterglow Wireless headset is programmed to remember your headset's chosen color.
the next time you turn on your Afterglow Wireless headset, the ear cups will be the color you
had previously chosen.
aUtoMatic liGHtinG: the Afterglow Wireless headsets also has the capability of cycling
through all colors of the spectrum while in use. Move the switch on the left ear cup to the light
bulb icon with an A. the ear cups will continue to cycle through the prismatic colors during use.
english
liGHtinG oFF: to turn off your ear cup lighting, simply move the switch to the crossed light
bulb icon. *note: in this mode, the headset functions will operate normally.
english
m
a