Accu-Turn 1500 Manuel De L'opérateur page 24

Operations
Adapter Mounting (optional).
Refer to Figure 5.1-3. From top to bottom:
(A) Universal Wheel Adapter #14026608
Remove the threaded shaft then fit the adapter.
For 3 holes: fit the 3 stud bolts in the holes stamped
with the number 3.
For 4 holes: fit the 4 stud bolts in the holes stamped
with the number 4.
B
For 5 holes: fit the 4 stud bolts in the holes stamped
with the number 5.
A
Adjust the hole diameter using the caliper supplied
and tighten the stud bolt screws. Fit the wheel.
(B) Kit for light truck wheels #14026401.
For mounting light truck wheels with a center hole of
diameter 120 to 174mm.
(C) Motorcycle Rapid Flange D.14 #14026397.
Remove the threaded shaft then fit the adapter. Fit
the motorcycle wheel using the cones supplied and
adjust the drive fork so that the wheel cannot turn
relative to the shaft.
C
(D) Motorcycle Shaft Kit D. 10 #14026412.
For use with the rapid flange #4026397
(E) Harley Davidson Shaft Kit #14026413.
For use with the rapid flange #4026397
(F) Single-arm Ducati Adapter #14026420.
D
For use with the Harley Davidson kit #4026413
(G) Single-arm BMW adapter #14026415.
For use with the rapid flange #4026397
(H) Single-arm Honda Adapter #14026417.
E
Remove the threaded shaft then fit the adapter.
(I) Single-arm Aprilia Adapter #14026419.
Remove the threaded shaft then fit the adapter.
F G
H I
5.1-3
Operator's Manual ACCU 1500
24