Dab+ Operation - Facom BSYS.BPMUSIC Notice Originale

14 . Repeat steps 1 and 2 to set additional
preset stations .
15 . Press the Back button (
the Audio Source screen .
16 . The selected station is indicated on the
LCD screen (button 2 in the example
below) .

DAB+ OPERATION

17 . When first turned on or after restoring
to default settings, the appliance will
automatically run a full station scan to
find broadcasting stations .
18 . Use the Selection dial to scroll through
the stations .
DAB+ MENU
Full Scan
19 . Press the Selection Dial (
to browse through the menu .
20 . When Full Scan is chosen, the appliance
will run a full band scan, displaying the
number of stations found .
21 . When complete, the appliance will play
the first station on the band .
Stations List
When selected, the appliance will display the
full list of available stations . Browse the list
using the Selection Dial (
select a station .
NOTE: When moving locations or if reception
was poor in the original scan, this may result
in an empty or incomplete list of available
stations . Manually running an Full Scan will
find all available broadcast stations .
Setting Favorites (Presets)
1 . Set the radio to the desired station
(see Full Scan) .
2 . Press and hold the desired preset button
( ) until a message >> P# is
displayed . The station is saved to the
displayed preset button number (#) .
3 . The selected station is indicated on the
LCD screen .
Information Display
The following information can be selected to
be displayed on screen:
1 . Scrolling Text – loop through all types of
information, 3 seconds each .
2 . Frequency - the playing station's
frequency .
NU-BSYS.BPMUSIC_0617.indd 35
3 .
) to return to 4 .
NOTE: The information is provided by the
stations, and not controlled by the appliance .
DAB Settings
1 .
2 .
), and turn it
NOTE: DRC only works if it is enabled by the
broadcaster
IMPORTANT RADIO NOTES
) and press to
3 .
4 .
ADJUSTING THE SOUND
PREFERENCES
Sound preferences can be adjusted by changing
the equalization of the Bass, Treble or Mid .
1 .
2 .
3 .
4 .
5 .
6 .
Type - the type of media broadcast
made by the current station .
Data rate - the resolution that is
broadcast by the station .
Prune stations - Some stations
previously received by your radio that
might no longer be available will display
blanks in place of the station name . To
remove these stations from the station
list press the Selection Dial (
You will be asked to confirm your choice
(similar to "Restore to Default") .
DRC (dynamic range compression) -
This function reduces the difference
between the loudest and quietest audio
being broadcast . Effectively, this makes
quiet sounds comparatively louder, and
loud sounds comparatively quieter . The
following options are available:
• DRC off
• DRC low
DRC high
•
Reception will vary depending on location
and strength of radio signal .
Running the radio while connected to
certain generators may cause background
noise .
Press the selection dial (
Rotate the selection dial clockwise until
Main Menu is reached .
Press the selection dial to access the Main
Menu .
Press the selection dial again to enter the
Sound settings screen .
Adjust to the desired setting by rotating the
selection dial clockwise/counterclockwise .
Press the selection dial to scroll through
the sound setup options .
Pressing ( ) saves the selected setup .
EN
) .
) .
35
30/06/2017 08:04:04