Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Setting Magazine Screw Length (Fig. E)
This magazine is designed for 1"–2" (20–50 mm) screw
lengths. Failure to set the correct screw length can cause
screws to not be driven accurately which can result in the
failure to advance to the next screw or screws not being
driven properly. The shoe has marked specific slots for each
of the most common screws, however this attachment can
still drive any size screw between 1"–2" (20–50 mm). To
accommodate for less common screws adjust to the next
longest slot.
CAUTION: Do not adjust while a screw strip is in
the magazine.
1. Slide screw length adjustment tab
2. Holding the screw length adjustment tab in place,
adjust the shoe
to the desired length.
7
3. Release the screw length adjustment tab. Make sure
that the locking pin has fully returned and is in the
correct position.
Fig. E
Inserting Collated Screw Strips (Fig. A, F)
NOTICE: Use only screw strips that are suitable to
this magazine. Only insert screw strips when the
screwdriver power is off and the trigger is locked.
Proper use of collated strips will reduce the risk of
injury, reduce jams and prevents screws from damaging
workpiece. For best performance use new, undamaged
strips free of debris.
1. Take a collated strip, holding the plastic portion, and
feed from the bottom of the screw guide
the bottom of the advancing mechanism
2. Continue feeding the strip until the first screw is 1 slot
below the driver bit.
nOTE: Do not pull screw strip out from bottom.
continue to pull screw strip out through the top
if needed.
4
Fig. F
2
to the left.
Setting Screw Depth (Fig. A, G1, G2)
Turn fine depth adjustment knob
viewed from behind the tool) to reduce the screw drive
2
depth into the workpiece.
Turn the fine depth adjustment knob
7
increase the screw drive depth into the workpiece.
There is a fine depth adjustment indicator
adjustment wheel which displays the screw depth setting.
When the slider
nose of the tool, as in Fig. G2, the screw driving depth is set
to the deepest possible position.
When the slider is closest to the nose of the tool, as in
Fig. G1, the screw driving depth is set to proudest (most
raised) position.
Fig. G1
1
and into
5
.
Driving Screws (Fig. A)
1. Before driving screws, ensure screwgun drive direction
2. With the magazine installed on the screwgun, position
3. Switch the screwgun on by holding the trigger in the on
4. Apply pressure against workpiece. This will advance
5. Continue to apply consistent pressure until screw is
6. Lift screwgun from workpiece.
5
1
of the gauge is furthest back from the
14
Fig. G2
14
is switched to forward position.
shoe
7
on workpiece in location where screw is to
be driven.
position. Continue to hold trigger or engage the trigger
lock-on.
screw into alignment with screwdriver bit.
driven in completely and screwgun clutches disengage.
3
counterclockwise (as
3
clockwise to
4
next to the
14
Publicité
Table des Matières
