LENCO MC-013 Mode D'emploi page 8

TUNE TO A FM STATION PRESET
In FM mode:
Press P+ P- button to move to the preset location and station that you would like to listen to (1-30). When
you pause between each press the frequency stored under each preset location will be displayed and
the Micro will tune to and play the stored station�
COMPACT DISC PLAYBACK
CD mode
Check that your Micro is in CD mode. If you are not already in CD mode, briefly press and release the
'Mode' button until you are in CD mode (check the display)�
Play a CD
1� Press and release the lid of the CD player on the front right edge� 'OP' will be displayed�
2� Place an audio CD, label side up, into the CD compartment� Please ensure that you line up the hole
in the center of the CD, with the central spindle and press down into place�
3� Close the lid of the CD player, pressing down on the front right edge, ensuring that it 'clicks' shut� '_ _ _'
will be displayed and after a short delay the number of tracks on the CD will be displayed� And it will
play automatically of the 1st track�
Note: If there is no CD in the compartment, 'no' will be displayed�
CD controls
You can use the following controls on your Micro in CD mode�
• Play
Press button on the Micro. The track will begin to play and the 'PLAY' icon will be displayed.
• Pause
Press button. The 'PLAY' icon and the elapsed time of the track will flash.
Press button again to continue to play the track
• Next track:
Press Tune button�
• Previous track:
Press Tune button�
• Fast forward within a track:
Press and hold the Tune
• Fast backward within a track:
Press and hold the
• Stop
Press and release the
button�
Tune button�
/ button�
8