Step 13 Install Cylinder Access Panel; Step 14 Replace Engine Access Panel - Endless Summer 153110 Manuel D'utilisation

11
Contact 1-800-762-1142 for assistance.
Step 13 – Install Cylinder Access Panel
• Line up holes on Latch with slots on Cylinder Shroud. Attach with (2)
• Line up holes in Access Panel hinges with holes in recessed area of
• Swing Access Panel closed and slip Latch over panel hook and
Step 14 – Replace Engine Access Panel
• Slide Igniter wire onto Igniter post.
• Position Engine Access Panel back in place.
• Secure Panel in place with 3 screws previously removed from side
Note: Once you have successfully completed assembly steps 1-15 you
are ready to begin operating your heater.
If you wish to permanently mount your heater to a deck or patio, use the
5/8" hole in the base to attach it to an anchor bolt.
Owner's manual and assembly instructions: model 153110 natural gas outdoor patio heater
Do not return to place of purchase.
Latch Screws and (2) Latch Nuts.
left leg. Attach each hinge with (2) Hinge Screws and (2) Hinge Nuts.
snap shut.
and bottom holes.
12/4/02