Sanycces SPA 407 Manuel D'installation page 3

GB
Index
Warnings . . . . . . . . . . . . . . . . . . . . 2
Necessary Tools . . . . . . . . . . . . . . . . . 2
Location . . . . . . . . . . . . . . . . . . . . . 6
Transport . . . . . . . . . . . . . . . . . . . . 8
Components . . . . . . . . . . . . . . . . . . . 9
Installation . . . . . . . . . . . . . . . . . . . 9
Warnings
Check to ensure the product is free of defects after unpacking. Under no circumstances shall the manufacturer be held responsible for defects which are not
reported upon receipt of the product.
It is recommended that a qualified electrician perform the electrical installation and set up, and test and certify the electrical circuits before and after connec-
ting the product. The installer is responsible for any parts damaged during installation.
Your local authorities may impose certain specific restrictions and/or requirements. Check with your local authorities if you are in any doubt. It is the respon-
sibility of the owner/user to ensure, by means of qualified personnel (architects, engineers, etc.), that the surface on which the spa is to be installed is capable
of withstanding the weight of the same with water and persons.
A certificate must be obtained from the electrician confirming that the entire electrical circuit which impacts on or may possibly impact on the operation of
the spa has been tested.
The electrical supply for this spa must be provided by an exclusive circuit which must not be shared by other equipment.
Connection to earth in accordance with regulations is essential. The equipment connected to earth must remain permanently connected to the fixed elec-
trical wiring system.
The electrical installation must operate at 230V and must extend to the location where the spa is to be installed. It must remain permanently connected to
the electrical supply.
Connection to appropriate thermomagnetic circuit breaker and a residual current device (RCD) with an operational differential current rated at no greater
than 30 mA is essential.
Electrical system cable length > 2m. Cable section of 2.5 mm .
2
The conductor sections should take into account not only the consumption of the installation, but also the path of the cables and their lengths, the chosen
protection systems and the regulations in force regarding stable electrical installations in the country where the spa is to be installed.
A section switch must be installed for the electrical connection which ensures an all-pole cut-off, directly connected to the power supply contacts and where
the contact is separated at all of its poles, providing total disconnection under conditions of category III overvoltage.
In accordance with regulations in force, the switch and the other electrical devices must be located in an area which is impossible to reach by a person using
the spa (in accordance with areas prohibited in the Low Voltage Electrotechnical Regulations).
The electrical outlet and plug must be directly connected without the placement of multiple outlets, adaptors or extension cords between them.
WARNING: Any damage which may be caused by an inadequate electrical installation is excluded from the warranty. It is the responsibility of the owner/user
to contract an electrical supply which has been duly certified by qualified personnel. The manufacturer's warranty shall be null and void in the event that the
recommended power is not supplied.
The installer is responsible for checking the plumbing system.
Always disconnect the electrical supply before carrying out any maintenance on the spa.
The company reserves the right to modify any of its products as well as the installation and users manuals of said products without any obligation to
forewarn or substitute.
Necessary Tools
2