Rittal MC 125 Notice D'emploi page 18

5 Assembly
EN
18
Item Qty.
1 1
2 1
3 1
4 1
5 1
6 5
7 5
8 5

Attachment on a firm and tilt-proof base e.g. workbench (work plate thickness:
40 mm; through holes for five screws (M8); secure each screw from below by
means of a washer and a screw nut; nut torque: 10...15 Nm).
Note:
Set position and location of the device and transfer attachment
points to base. Use mounting parts that are suitable for the subsur-
face.
Description
Table left 250 mm
Lever
Table right 1060 mm
Stop angle
Support angle for table
Countersink screw
Washer
Hexagon nut
Rittal Wiring duct cutter MC 125