Load Laundry - Whirlpool AWG812/PRO Consignes D'installation, Utilisation Et Sécurité

HOW TO USE THE WASHING MACHINE
1.

LOAD LAUNDRY

• Open the door and load the laundry .
Observe the maximum load sizes given in
the programme chart .
2.
CLOSE DOOR
• Make sure that no laundry gets
stuck between door glass and
rubber seal .
• Close the door so that you can hear it click shut .
3.
OPEN WATER TAP
• Make sure that the washing machine is
connected to the mains .
• Open the water tap .
4.
SWITCH ON WASHING MACHINE
• Press the On/Off button until the
programme button lights up . An
animation will appear, and there will be a sound .
Afterwards the washing machine is ready to be
operated .
• The programme setting which you used last will
appear on the control panel .
5.
SET THE DESIRED PROGRAMME
GUIDED MODE
the button light will guide you through setting a
programme in the following order: selection of
programme / temperature / spin speed / options .
As soon as you confirm a selection by pressing the
knob, the button light will jump to the next step .
Select programme
Make sure that the programme button lights up .
Turn the knob to select the desired programme .
The indicator next to the selected programme
lights up .
Confirm the desired programme by pressing the
knob .
188
Find more information regarding programmes in
the Programme Chart .
Change temperature, if needed
If you want to change the temperature
indicated on the display, make sure that the
Temperature button « lights up .
Turn the knob to select the desired temperature,
then press the knob to confirm .
Change spin speed, if needed
If you want to change the spin speed
indicated on the display, make sure that the
Spin button lights up .
Turn the knob to select the desired spin speed, or
Rinse hold , then press the knob to confirm .
If you select spin speed "0", the programme ends
with draining the rinse water . No final spin cycle
will be applied .
If you select "Rinse hold", the programme will
stop after the rinse phase . The laundry will remain
immerged in the last rinse water . See more
information in section PROGRAMMES, OPTIONS
AND FUNCTIONS / Rinse hold.