Use Of Detergent - Greencut JET-3200 Manuel D'utilisation

38
7. Place the safety lock on the gun.
ATTENTION: Always disconnect the motor from the appliance before turning off the water supply
to the appliance. The motor can be seriously damaged if the appliance is started without water.
ATTENTION: Never disconnect the high pressure discharge hose from the appliance while the
system is still pressurized. To depressurize the appliance, turn off the engine, shut off the water
supply and pull the trigger 2-3 times.
NOZZLES
The machine comes with 5 different nozzles. Each nozzle is color-coded for identification and produces a different
spray pattern for different tasks.
• Red - 0° scattering angle. Highest possible pressure for difficult cleaning tasks, including stained concrete and
paint removal. Not recommended for soft materials or automotive applications.
• Yellow - 15° scattering angle. Very high pressure for difficult cleaning tasks, including concrete, covers and paint
removal. Not recommended for soft materials or automotive applications.
• Green - 25° scattering angle. High pressure for general cleaning tasks, including automotive.
• White - 40° scattering angle. Moderate pressure for general cleaning of larger surfaces.
• Blue - 65° scattering angle, low pressure for general cleaning of larger surfaces and when using detergent.

USE OF DETERGENT

1. Add detergent to the tank.
2. Place the spray nozzle in the low pressure position.
3. Tighten the spray gun to spray with detergent.
GUN SAFETY DEVICE
Whenever using the pressure washer, we recommend that you hold the device properly, with one hand on the grip
and the other on the lancet. When stopping the appliance, use the safety lock (A) on the pistol to prevent accidental
start-up.
CLEANING INSTRUCTIONS USING THE FORK
Use the included cleaning fork, or a folded out paper clip, insert the tip of the fork into the nozzle and move it forward
and backward until the dirt is removed.
Remove extra dirt by passing water through the nozzle. To do this, place the garden hose (with water passing through)
at the end of the nozzle for 30-60 seconds.
A