General Warnings; General Information; Scope Of Delivery; Parts Overview - Bresser MyTime LEDsec Mode D'emploi

ABOUT THIS INSTRUCTION MANUAL
These operating instructions are to be considered a
component of the device. Please read the safety
instructions and the operating instructions carefully be-
fore use. Keep these instructions for renewed use at a
later date. When the device is sold or given to someone
else, the instruction manual must be provided to the new
owner/user of the product.
This product is intended only for private use.

GENERAL WARNINGS

CHOKING HAZARD!
Keep packaging material, like plastic bags and rubber
bands, out of the reach of children, as these materials
pose a choking hazard.
RISK of ELECTRIC SHOCK!
This device contains electronic components that operate
via a power source (batteries). Children should only use
the device under adult supervision. Only use the device as
described in the manual; otherwise, you run the risk of an
electric shock.
RISK of FIRE/EXPLOSION!
Do not expose the device to high temperatures. Use only
the recommended batteries. Do not short-circuit the de-
vice or batteries, or throw them into a fire. Excessive heat
or improper handling could trigger a short-circuit, a fire or
an explosion!
NOTE!
Do not immerse the unit in water.
Do not subject the unit to excessive force, shock, dust,
extreme temperature or high humidity, which may result in
malfunction, shorter electronic life span, damaged batter-
ies and distorted parts.
Do not disassemble the device. In the event of a defect,
please contact your dealer. The dealer will contact the
Service Centre and can send the device in to be repaired,
if necessary.
Use only the recommended batteries. Always replace
weak or empty batteries with a new, complete set of bat-
teries at full capacity. Do not use batteries from different
brands or with different capacities. Remove the batteries
from the unit if it has not been used for a long time.
The manufacturer is not liable for damage related to im-
properly installed batteries!
6

GENERAL INFORMATION

This item is available in the following variants. The func-
tions and technical data are the same. They only differ in
its design/in its colour.
8020215 CM3000: MyTime LEDsec, black
8020215 GYE000: MyTime LEDsec, white
8020215 SX9000: MyTime LEDsec, blue
8020215 MGU000: MyTime LEDsec, grey
8020215 B4K000: MyTime LEDsec, green
8020215 URJ000: MyTime LEDsec, purple

SCOPE OF DELIVERY

Wall clock, Instruction manual
Required batteries:
1 x 1.5V battery (Size AA/LR6)
Battery compartment for LEDs:
4 x 1.5V batteries (Size AA/LR6)
Batteries not included with purchase.

PARTS OVERVIEW

Wall clock (Fig. 2)
1. Dial plate
2. 5 seconds display (lights up)
3. Clock hands (hours, minutes)
4. Temperature display (indoor)
5. Motion sensor for temperature display
6. Wall mount
7. Battery compartment for the clockwerk
8. RESET button
9. REC button
10. M.SET button
11. Locking pin
12. Reset 5-second interval
13. Battery compartment for the LEDs
GETTING STARTED/POWER SUPPLY
1. Remove the locking pin (11) from the clockwork.
The clock can be operated only after the pin has
been removed.
2. Insert 1 battery (1.5V, AA/LR6) into the battery com-
partment (6).
3. Make sure to place the batteries strictly according to
the right polarities (+/-) as shown in the battery com-
partment.
Battery compartment for LEDs:
Insert 4 batteries (1.5V, AA/LR6) into the battery com-
partment for the LEDs (13).
The wall clock has a light sensor that automatically ad-
justs the brightness of the LEDs to conserve battery life.
(Fig. 1)